Back to Blog
    Plumbing

    What’s Covered in a Well Inspection: A Home Inspector’s Comprehensive Guide

    Justin BirtwellDec 17, 20256 min read
    What’s Covered in a Well Inspection: A Home Inspector’s Comprehensive Guide

    Unlike municipal water, wells are your responsibility, and failures can lead to contaminated water, costly repairs, or even health risks. A thorough well inspection evaluates the system’s components for safety and efficiency.

    In this post, I’ll walk you through exactly what a professional well inspection entails, based on standards from the American Society of Home Inspectors (ASHI) and my field experience.

    Starting at the Source: The Well Head and Casing

    The well head is the visible top of your well-the entry point where water is accessed and protected.

    • **Location of the Well Head**: I start by noting its position relative to potential hazards. Codes require wells to be at least 50 feet from septic tanks, 100 feet from drainfields, and 10 feet from property lines.
    • **Well Head Height**: The head must extend at least 12-18 inches above grade to prevent surface water entry during heavy rains or snowmelt.
    • **Condition of the Well Head and Casing**: The head should be secure, vermin-proof, and vented properly. The casing must be intact without dents or corrosion.

    !Measuring the well head height

    Inside the System: The Pressure Tank

    Once the head is clear, we move indoors (usually the basement) to the pressure tank. I document the manufacturer (e.g., Well-X-Trol by Amtrol), check tank age (10-20 year lifespan), and inspect for rust, leaks, or waterlogging.

    !Well pressure tank inspection

    The Pressure Switch: The System’s Brain

    The pressure switch controls when the pump turns on/off based on tank pressure (30/50 or 40/60 PSI). I inspect contacts for arcing or pitting.

    !Pressure switch electrical contacts

    Performance Testing: Putting It All to the Test

    • **Flow Test**: Running multiple fixtures to measure GPM (minimum 3-5 GPM).
    • **Flow Pressure**: Gauge testing PSI during continuous flow (40-60 PSI ideal).
    • **Electrical Current**: Clamp meter checks pump amp draw to detect motor drag or electrical shorts.
    • **Pump Cycle Time**: Timing refill speed to detect waterlogged tanks.

    !Flow meter showing 3.6 gallons per minute

    What My Well Inspection Does NOT Include - A true well yield test - A recovery rate test - A draw-down test

    These tests require pumping the well dry using specialized 4-8 hour pump tests that only a licensed well contractor performs.

    Need a Thorough Home Inspection?

    Save $20 when you schedule online using promo code SAVE20.

    Schedule Now

    More Articles

    Plumbing

    Protect Your Pipes from Freezing

    Frozen pipes are one of the most common and expensive winter problems homeowners face. Learn how insulation, heat tape, and anti-freeze spigots protect your plumbing.

    Read Article
    Health and Safety

    Different Colors of Mold Explained

    Mold can appear in black, green, white, yellow, and purple. Learn what each color means for your home's health and indoor air quality.

    Read Article
    Hi there! Have a question? Chat with us here.